Broadcast SRC-32 Instalační příručka stáhnout pdf (Strana 8)

GPI Install Guide

_____________________________________________________________________

USB GPI-8 Install for Window 2000 or Windows XP

The USB GPI-8 can be used by machines that lack an available PCI slot

or can not utilize a PCI GPI because of BIOS limitations.

NOTE: Support for these units was added in DAD 4.2k28 (Jun.06.03)

Here are the steps for installing a USB GPI-8 in Windows 2000 or

Windows XP

1. Install the Switch and Sense software. If the software is not available, it can be

downloaded from the FTP site:

ftp://ftp.enco.com/pub/drivers/GPI/USB/Switch&Sense8.zip

2. After the software has been installed, physically connect the USB GPI-8 to the

workstation and power the USB device.

3. Go to START > PROGRAMS > COMPUTER BOARDS and run

the Switch & Sense 8 software. This MUST be run once with

the user clicking on a relay at least one time.

NOTE: This MUST happen before DAD will see the USB

device.

4. Start up DAD. After DAD has loaded. Go to SETUP and select

CFG & README. Open the workstation’s CFG file.

5. Scroll down towards the bottom of the file and find the line REMOTE = 0.

Modify this line to: REMOTE = CBUSB8

Also modify the line GPI_GPO = 8 8 16

6. Save the changes and close the file. Hit the yellow REFRESH Button, then EXIT

DAD. Once DAD has exited, reboot the PC.

To test the card, start DAD, open the LIBRARY, open the COMMAND window and type

the line PULSE GPO 1 1000 and hit EXECUTE. This will send a relay from DAD to

GPO 1. One should be able to hear a “click” on the unit itself when the relay opens,

then closes.

Other notes:

If a different unit has been plugged into a pre-configured

DAD workstation, the application will say there is a unit on 0

and 1. One should delete the unit on 0 (select the unit and

press the big red X). After doing this reboot the workstation.

When the workstation reboots, go back into the application

and Test a relay. Now DAD will talk to the new unit.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 17 18

Žádné komentáře

Broadcast SRC-32 Instalační příručka Strana 8