Broadcast SRC-32 Instalační příručka stáhnout pdf (Strana 2)

GPI Install Guide

_____________________________________________________________________

PCI GPI-8 or GPI-16 Install for Windows 2000

A GPI-8 card will have a heavy gray cable with a molded female 37-pin

connector.

The GPI-16 uses the same instructions except where noted within the guide.

A GPI-16 will have two flat ribbon cables that attach to the card and

pass through a slot, out the back of the computer.

The connector port closest to the slot on the card is for GPI/O 1-8

while the connector in the middle of the card is for GPI/O 9-16.

Here are the steps for installing a PCI GPI-8 or PCI GPI-16 card in Windows 2000

Professional.

IMPORTANT: One should check the BIOS of the machine for the option:

PLUG and PLAY OS = YES/NO.

This option should be set to NO. If the computer BIOS does not have this option, one

might not be able to get the PCI GPI card to function. In this case, one should consider

using a USB based GPI device.

1. Shut down the PC and install the card into an available PCI slot. Once the card has

been installed, re-power up the PC.

2. Go to the START menu. Select PROGRAMS>ADMINISTRATIVE

TOOLS>COMPUTER MANAGEMENT.

3. Under the DEVICE MANAGEMENT section there should be a device with a “?” in

front of it. RIGHT-CLICK on the device and select PROPERTIES.

4. Select the RESOURCES tab. This should display two I/O

addresses.

Use the lower left-hand address range

NOTE: If the card does not respond after the

installation is finished, repeat the process using

the upper left-hand address range.

5. Close the Device Properties screen and the Computer

Management Screen and open the COMMAND PROMPT.

6. Type CD \ (This should give a C:\ prompt)

7. Type and enter: CD DAD\DRIVERS.NT\GPI

As of DAD version 5.0+ the path to enter is: CD DAD\DRIVERS\GPI

1 2 3 4 5 6 7 ... 17 18

Žádné komentáře

Broadcast SRC-32 Instalační příručka Strana 2